Scored Shaft Repair

Modified on 2009/04/21 18:42 by jayeson Categorized as Bearings, Restoration Topics

''by [http://www.owwm.com/members/detail.aspx?id=312|Bob Vaughan] {Reference:http://owwm.org/viewtopic.php?t=28118 |http://owwm.org/viewtopic.php?t=28118}.'' 
{rating}

Working on a Delta 17-600 VS drill press, I discovered a scored shaft that had to be either replaced or repaired. The new cost of $200.00 + motivated me to try something. I know of the warping risk of the weld-up trick on steel this small, so that was out. This trick seemed to work. Next time, I may make a bushing twice as long as needed, and split it offset so it will clamshell on the shaft with less of a gap. 

Here's the shaft with the two 6205 bearings and pulley spacer. 


[image| |{UP}ScoredShaftRepair/ashaft1.jpg]

The shaft was .011 undersized so knurling was out. 

[image| |{UP}ScoredShaftRepair/ashaft2.jpg]

Act of despiration time. I cut a groove about 1/16" deep then made a bushing a little oversize on the OD and a little oversize (.005) on the ID for glue adhesion. I cut the bushing, spread it open, slid it down the shaft, coated the groove with JB weld, slipped the bushing into the slot, and clamped overnight with a hose clamp. 

[image| |{UP}ScoredShaftRepair/ashaft3.jpg]

Here's the result, right out of the clamp. 

[image| |{UP}ScoredShaftRepair/ashaft4.jpg]

I chucked the shaft in the lathe and turned down to the needed 25mm.

[image| |{UP}ScoredShaftRepair/ashaft5.jpg]

Here's the results. The bearing went on with a good fit and the machine has been running in a school for a month now. I beleive its a permanent repair until the bearing fails again. 

[image| |{UP}ScoredShaftRepair/ashaft6.jpg]

Meta Keywords:
Meta Description:
Change Comment:

	Welcome Guest, • Login
Wiki Home \| VintageMachinery.org Home \| OWWM.org Home \| Donate	Search the Wiki: »